With DM material board, chipboard or plywood, 8-10 mm. thick, we the staff of the top and bottom of the case. We use the same template for mold. What we do with the Tupi hand we've been using. After sanding and leave it rough, we see that this template fits perfectly into the mold by placing both her back and stomach. That will ensure that the mold is perfectly symmetrical. I should not have too much slack nor that there is any brake that prevents moving the template inside the mold.
Using the template mark on the board of 3 mm. thick lines cut and scored 4 pieces. The cut to about 5-6 mm. edge and began to glue with white glue as a carpenter. 
need a pair of thick boards or plywood hard wood planks that serve us to make a press. Just give him a piece and glue stick over the other. With two small nails put one at each end so it does not move at the time of pressing. We put a few sheets of newspaper between the board and each pair of pieces that we are not sticking to each other at the time of setting of the queue because always when tightening with the sergeants, expel the excess glue.
This is the result of gluing. We have already prepared the top and bottom of the case. Another solution would be to buy a board of 6 mm. thick and spare us this work. 
Here we set the template with a pair of small screws at each end against one of the lids so they can be machined with the Tupi manual.
This is the time of mechanization with the Tupi. At the end, loosen the screws that join the workforce and passed to do the same with the bottom cover to be identical. 
0 comments:
Post a Comment