After the previous stage of molding and bonding of the rings. We study the connection between the rings and cap. As the process is similar to the box only explain it. As shown in the photo, I set a nail a wooden listoncitos inside the mold to work better with the top sides and much thinner.
seen in this image internal molds to set in place the rings, used in the sizing.
Here we see the sizing of rings and cap. I put the lid on the bottom and I tail with a brush on the edges of the rings and clamps and fixed internal molds and let it set around 12 hours.
Profit after gluing.
box lid and finished.
order the mast to sit at the height of the nut, made of 6 mm plywood. thick this piece and adjust in the box, set carpenter's white glue and four small nails.
Put a photo of the bevel
After sanding the whole. Proceed to drill holes with 2 mm in diameter spaced 1 cm. and about 15 mm. edge. It will cover both as in the case.
0 comments:
Post a Comment