Monday, January 12, 2009
Stomach Flu Phoenix 2011
hoops to make the box and the lid need to cut against the grain board 3 mm. thickness as follows:
These pieces have more than a few millimeters across, because once glued together, their edges should be brushed, and remain perfectly flat for bonding with lids.
- 2 pieces of 85 x 1220 mm
- 2 pieces of 75 x 1220 mm
- 2 pieces of 35 x 1220 mm
- 2 pieces of 25 x 1220 mm
These pieces have more than a few millimeters across, because once glued together, their edges should be brushed, and remain perfectly flat for bonding with lids.
As the junction between lid and box timber is half, dropping 1.5 m of parts of 85 and 35 meters wide because you have to take into account the thickness of skay more adhesive, so that cap fits perfectly.
bending rings:
Phase 1.
start by soaking the pieces of 75 mm. for 10-15 minutes and mark with pencil the areas of curvature for applying heat the tamer rings , we are shaping it according to the curves of the mold. After the bend we put into the mold and fixing with clamps or we put some listoncillos Paperclip about 15 x 75 mm to avoid damaging the blades. Will need two strips. The second strip, smaller will be cut to as we enter the mold and must be perfectly adjusted. Later, with a heat gun or hair dryer to remove all moisture from the plate and allowed to rest in pan 12-15 hours.
Phase 2.
The next day, without removing the first ring and molding, is Proceco with strips of 85 mm. doing the same process the previous day, but moving laterally about 10 cm piece. the junction of the ring and folded and shaped. This ring will build on the previous. Use the same process of drying with hot air gun. Let stand 12-15 hours at least.
This phase would be the gluing of the two plates with white glue and carpenter's the first thing we do is lined with newspaper and masking tape inside the mold. It is applied with a brush tail in one of the plates (should not be limited) and the plates suck pretty tail. The mold must be fixed horizontally to the bank, a board or work table by a pair of sergeants and a few sheets of paper to avoid staining. Fasten the sheets once glued to the corresponding vertical listoncillos sergeants and described above. With a wooden bar and a hammer will go by tapping on the hoops (being careful not to damage them) so that it rests on the desk. If everything is properly left to dry about 12-15 hours.
Subscribe to:
Post Comments (Atom)
0 comments:
Post a Comment